Before Project Begins
Obvious signs of moisture issues on the concrete block walls. Mold is also starting to grow on the walls.
Close up of Water Damage
More areas of water damage. Water is seeping through the concrete block.
Excavating Perimeter
Excavating the areas around the basement perimeter that the WaterGuard will be installed into.
Getting Ready to Install WaterGuard
After we excavate the area, we clean all the debris. CleanSpace is also added to the concrete block wall as a moisture barrier.
WaterGuard
WaterGuard is being installed around the perimeter of the basement walls.
CleanSpace Liner
CleanSpace liner has been installed on the concrete block walls as well as over the WaterGuard.
Clean Up
Cleaning up of the areas after installation before a thin layer of cement is added over the WaterGuard.
WaterGuard Fully Installed
The WaterGuard is fully installed now and has been covered in a thin layer cement. This secures the product into place.
The TripleSafe Sump Pump
Our most reliable sump pump system, the TripleSafe™ Sump Pump System, provides three levels of protection for your basement and your peace of mind. For normal functioning, the TripleSafe™ has a powerful, cast-iron Zoeller® ⅓ horsepower sump pump set at the lowest level. For heavy volumes of water or in case of primary pump failure, a second, more powerful Zoeller® ½ hp pump set a bit higher in the liner will take over.
IceGuard and WaterGuard
The IceGuard and WaterGuard system have been installed and buried. Many sump pump discharge lines are susceptible to freezing during the cold winter months. Our IceGuard® discharge line protection prevents this from happening, with no need for the homeowner to do anything! This specifically designed grated adapter is located outside where the discharge line exits the house. If the pipe underground freezes in the winter, water can still be pumped out without the worry of backups into your basement!