Basement Waterproofing Photo Album: Basement Waterproofing in Goodlettsville, TN

This customer in Goodlettsville, TN called Frontier for their basement waterproofing needs. To waterproof their basement we installed a WaterGuard sub-floor drainage system, a Trench drain, and a TripleSafe sump pump to pump water through the drainage lines. We also installed IceGuard to prevent floods from clogged or frozen discharge lines and a LawnScape system. Now their basement is dry and clean.

Before Project Begins

You can see were water has damaged this basement, the water line is high on the concrete block wall. All these items will be moved before we start installing the waterproofing products.

Excavation for WaterGuard

The perimeter of the basement is excavated to get ready to install the WaterGuard system.

Weep Holes

Weep holes are drilled at the bottom of the blocks to drain the hollow cavities.

WaterGuard System

The system sits on top of the footing, away from the "mud zone" underneath your floor. Water is collected without the risk of clogs that would halt your system.

Trench Drain

The Trench drain is put in place. This allows water to flow into it before entering the basement. The Trench drain is used in high traffic areas like entrances.

Installation Process

After the WaterGuard is installed a thin layer of CleanSpace liner is placed on top before it is covered with a layer of cement.

WaterGuard System Complete

The WaterGuard system installation is complete and covered with a thin of cement.

TripleSafe Sump Pump Installation

The TripleSafe sump pump is fully installed and a thin layer of cement is applied around it.

Trench Drain Installation

The Trench drain installation is complete and set into place with a thin layer of cement.

IceGuard® system

Water escapes from the IceGuard® fitting only when the discharge line becomes clogged. Otherwise, water flows past the slotted openings into the drain pipe.