Water Damage
Water is pooling in the basement. It is pooling around the bottom of the concreate block wall, if not addressed it will lead to mold and sinkage and structural damage to the basement and home.
Mold and Mildew
The water leakage is starting to cause mold growth on the concrete block. This will continue to get worse if not mitigated.
Excavation Process
An area around the perimeter is excavated to place the WaterGuard subfloor drainage system.
Waterproof concrete block foundation walls
Weep holes are drilled at the bottom of the blocks to drain the hollow cavities.
WaterGuard® System Placed
Our most popular drainage system, WaterGuard® is the ideal solution for most basement waterproofing applications. Unlike old-fashioned drain tile systems installed on the outside of the home, WaterGuard® is installed just underneath the perimeter edge of the basement floor.
Clean Gravel
Clean gravel is brought in to surround the WaterGuard system once it was put in place.
WaterGuard System Installation Process
After the WaterGuard system is in place, it is covered with CleanSpace liner.
CleanSpace®
CleanSpace® vapor barrier, a super-durable 20-mil plastic sheet designed to permanently prevent moisture, outside air, and pests from entering your crawl space. It is placed over the concrete block wall. The WaterGuard system is covered with a thin layer of cement.
TripleSafe Sump Pump
Our most reliable sump pump system, the TripleSafe™ Sump Pump System, provides three levels of protection for your basement and your peace of mind. For normal functioning, the TripleSafe™ has a powerful, cast-iron Zoeller® ⅓ horsepower sump pump set at the lowest level. For heavy volumes of water or in case of primary pump failure, a second, more powerful Zoeller® ½ hp pump set a bit higher in the liner will take over.